69 Mustang Rear End Wallpaper

Currie Ford 9-inch rearends are built to match the vehicles original equipment axle width pinion location suspension mounting points and wheel bolt pattern - for hassle-free installation that will get.

69 mustang rear end wallpaper. Image of cars details poster - 6440589. U joint flange measures 3-14 from end to. You will need one 26-38 long axle and one 28-58 long axle.

Its also narrower than a standard 67 Mustang which means I might be able to squeeze wider tires in the back. A bright blue with gold stripe 1969 Ford Mustang. The codes are as follows.

To keep your Stang handling like a dream you need the back axle to be in prime condition. I ordered it as a bolt in for our 70. These 1966 Ford Mustang Wallpapers are free to download so go ahead.

Cutting to the chase unusual I know the rear axle in my car is not original to the car but likely from a late-50s Ford sedan. The place to measure is from the sadle where it bolts on to the saddle on the other side then you can use any 9 rearend with the same sadle width. Find 1969 FORD MUSTANG Differential Rear-End Components and get Free Shipping on Orders Over 99 at Summit Racing.

There were 18 ratios offered on Mustangs From 1965 til 1967. Reproduction of the original 1964-69 Ford Mustang driveshaft slip yoke 6 cylinder with inside snap ring 28 spline 1965 170200 C4 Transmission 1967-69 200 3-Speed Transmission. 69 Ford Mustang Ring Rear End 15500.

A 9 housing with 3 tubes small bearing ends and leaf pads cost me 389 delivered from Currie. On the Rear End Ratios. Cars used front drop pumpkins while trucks used rear drop.